There are two types of brakes: hydraulic brakes and block brakes.

　　What should be paid attention to during the use of hydraulic brakes?

　　In order to ensure the uninterrupted operation of the hydraulic brake, it must be protected and protected frequently:

　　1. Lubricant is often added to the movable part of the electromagnetic brake.

　　2. Check the length of the armature stroke regularly. Because during the operation of the brake, the stroke length of the armature will increase due to the wear of the movable surface. When the armature stroke length does not reach the normal value, it is necessary to adjust to recover the minimum gap between the braking surface and the turntable. If the armature stroke length increases above the normal value, the suction power may be greatly reduced.

　　3. If the worn brake surface is replaced, the minimum gap between the brake surface and the turntable should be adjusted appropriately from the beginning.

　　4. Always check the tightness of the bolts, especially tighten the bolts of the electromagnet, the bolts of the electromagnet and the housing, the bolts of the yoke, the bolts of the electromagnet coil and the wiring bolts.

　　5. Regularly check the mechanical wear of the movable parts, and remove the dust, flower hair and grime on the surface of the electromagnet parts.